power hammer
英 [ˈpaʊə(r) ˈhæmə(r)]
美 [ˈpaʊər ˈhæmər]
网络 动力锤; 电锤
英英释义
noun
- a power tool for drilling rocks
双语例句
- Improvement on Design of Circulating Water System in Thermal Power Plants to Prevent from Water Hammer
为防止水锤现象火电厂循环水系统设计的改进 - Chapter two describes the basic equations of water hammer, pump boundary condition of pump stoppage caused by power failure, the boundary condition of upstream and downstream pond and commonly used water hammer measures in long distance water-supply systems.
第二章阐述水锤的基本方程、事故停泵水锤计算的水泵端边界条件、基本边界条件及长距离供水系统中常用的水锤防护措施。 - By means of power bond diagram and status space analysis, a computer simulation of the lifting process of the 2T airdraulic hammer was carried out and the same conclusion in accordance with the experiment was come to.
运用功率键合图和状态空间分析法，对2T气液锤的提升过程进行计算机仿真，取得了与实验一致的结论。 - 12t drop hammer test machine research on energy efficiency and arrangement of power system of hydraulic crusher with dropping hammer
12t落锤试验台液压落锤式碎石机动力系统配置及能量效率 - Different from past single-pipe engineering, the construction of long-distance water diversion project is complicated and lots of boundary conditions, and the analysis of water power condition consequently becomes one of the most important water hammer study.
不同于以往单管的输水工程，此类工程的结构更复杂，边界条件更多，其水力状态的分析也成为了水锤研究的一个重要方向。 - Hitting power study of hydraulic forging hammer based on elastic-viscoplastic body forging
基于锻件为弹粘塑性体的液压模锻锤打击力研究 - Researching the water power's transitional process may improve the water works 'security and reduce the investment by controlling the water hammer's harm and providing the effective defensive measures.
研究管道系统的水力过渡过程，通过控制水锤的规模，为管道提供有效的防护措施，可以提高水利工程的安全性，降低工程投资。 - This paper introduces a fuzzy governor-based power system stabilizer ( FGPSS) of hydro-turbine generator adopting the elastic water hammer model of hydraulic system and Philips-Heffron model of synchronous generator. Simulation studies are performed through Matlab/ Simulink.
采用水力系统弹性水击模型和同步发电机Philips-Heffron模型，设计了水轮发电机组调速器侧模糊电力系统稳定器（FGPSS），并应用Matlab/Simulink对其效果进行了仿真研究。 - Usually the compressive force is in the form of hammer blows using a power hammer or a press, as shown in Fig.4.1.
通常压力都是以由如图4.1所示的动力锤或压力机提供的锤击形式出现。 - Power Bond Graphs to Study Dynamic Features of Hydraulic Hammer
用键合图方法研究液压锤动态特性